Download or read book Rotational Moulding of Plastics written by R. J. Crawford and published by . This book was released on 1996 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: Rotational moulding has been available as a processing method for hollow plastic products for more than forty years, but for a long time it was regarded as a slow method limited to only a few plastics. Within the last ten to fifteen years there has been a dramatic change. Engineers and designers recognise the scope that rotational moulding offers for the production of relatively inexpensive, complex shapes with low levels of moulded-in stress. Materials suppliers are continually developing new grades of plastics as well as a wider selection of materials suited to the process. In addition, machinery suppliers are producing more sophisticated moulding equipment so that the moulder now has control over the process that was previously thought impossible. For its second edition, this book has been updated and expanded by the authors, who are leaders in their specialties within the field of rotational moulding. It continues to provide an introduction to the subject, as well as giving comprehensive coverage of the state-of-the-art. Two new chapters have been added. These cover the important areas of pin-hole removal from rotomoulded products and the rotational moulding of liquid polymers. In both cases the new material is the result of extensive research, and the results will be of considerable practical interest to moulders. The book will surely be welcomed again by moulders, materials and equipment suppliers, engineers and designers, and by lecturers looking for up-to-date information to include in their courses.