Download or read book CMOS Compatible Wet Bulk Micromachining for MEMS Applications written by S Santosh Kumar and published by . This book was released on 2019 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: Wet bulk micromachining of silicon is a convenient and economical method for realizing various silicon-based microsensors and actuators. Tetramethylammonium hydroxide (TMAH) based anisotropic wet etching is popular due to it being less toxic and CMOS compatible. The etch rate of TMAH depends on the wafer,Äôs crystal plane orientation and temperature/concentration of solution. While using TMAH to realize a pressure sensor diaphragm, the etching of {111} planes causes underetching, causing a deviation in the intended size of the diaphragm, inducing variation in the designed characteristics of the device. It is necessary to estimate and minimize these deviations. Experiments were designed and the rate of etching for (100) and (111) planes using 25¬†wt.% TMAH have been determined at different temperatures. Linear fit equations are obtained from experimental data to relate the underetch per unit depth to the solution temperature. These findings are extremely useful in the fabrication of silicon diaphragms with precise dimensions. While using anisotropic wet etchants to realize proof mass for accelerometers, the etchants attack the convex corners. This necessitates a suitable design of compensating structure while realizing microstructures with sharp convex corners. Experimental studies are carried out to protect convex corners from undercutting and the results are reported.